![]() Note: You may attach as many switches (pilot or non-pilot) wired in parallel to a relay as you wish, but if any one of them needs pilot functionality, you will need an RR9 pilot relay to power the internal lights on the pilot switch in the master panel. If you want to keep the pilot functionality on the switch in the master panel, you must use a pilot relay with it. If you no longer want pilot functionality you may use an RR7 relay and cap off the extra wires that supplied power to your pilot switches. Can I replace the relay with a non-pilot relay? I have switches wired in parallel but only the switch in my master panel needs a pilot light. The good news was that you no longer needed straps if you were using the switches with the new style switchplates. Do not attempt to jam the RS23X switches into the old straps - this will cause the buttons to stick and will cause the relay to burn out. Were the newer GE replacement switches (RS23X series) the same size as the old ones? If the system does not have dimming capability, an upgrade would be required to a panel with dimmer modules. Provided the fixture does not exceed the amperage of the relay itself (typically 20 Amps), it does not matter if it uses incandescent, fluorescent, LED, halogen, etc., bulbs. ![]() The parts were manufactured in the same dimensions switches often simply had a different logo imprinted on them.ĭoes it matter what type of fixture or bulbs I use in my system? They are based on the same type of low voltage wiring setup. ![]() Yes, the GE parts are compatible with Bryant systems. I have Bryant switches - can I replace my relays and switches with GE parts? If wires have been chewed by rodents or squirrels, you may experience unusual behavior in the system. If the switch seems at all sticky or slow to respond, it may be time for an update. Typically something causes the relay to fail, so be sure to test your switches, including any in a master panel that may be wired in parallel with the local room switch. Installing a new relay without replacing all switches attached to it.Installing a standard line voltage switch (even temporarily) where a momentary switch is required.The new switches are slightly larger than the vintage rocker/teeter-totter switches, so they will pinch the housing causing the switch buttons to stick. Putting a new RS2 type switch (black bordered) in an old ladder-type bracket.This is more likely to happen with switches or plates that are painted, wallpapered, or broken, or with switches installed in grimy locations such as kitchens. So as long as both switches are wired to the same relay, this will work as a 3-way, 4-way, etc., setup. GE switches can be wired in parallel to create a three way switch setup, such as when you need a switch at both the top and the bottom of stairs or at either end of a hallway. Check with your electrician to confirm how much is safe.ĭo I need to buy 3-way low voltage switches? No, you can wire up to five relays to one transformer, depending upon your setup. If you are using a master panel or have any switch with a light on it, you will need an RR9 pilot light relay to power that internal light bulb.ĭo I need one transformer for every relay? For example, if you have a switch in the master bedroom and a switch in the living room which both control the living room lights, they can be wired together in parallel so you can turn them off from either location, but they only need one relay.ĭo I need pilot light relays if the switch in my room doesn't light up? In more complex setups you might have one relay/fixture controlled by more than one switch (to turn on a fixture from either side of a room or from a master panel), or one switch controlling two or more relays (one switch controls two can lights in the ceiling at the same time). Yes, in a simple setup you need one relay and one switch for every light fixture.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |